VW Amarok Levelling Suspension Kit from Octane and Bilstein

Volkswagen's Amarok range of vehicles all sit nose-down by default. Using lifted Bilstein front springs and B6 dampers (front and rear), our kit raises the height of the front without putting undue stress on the front driveshafts to make the front and rear sit at the same height.

OCT2000-1 is our Bilstein suspension levelling and enhancing kit with applications for the VW Amarok 2010-2022 models.

Containing all you need to upgrade your vehicle’s ride, this kit includes two Bilstein B6 front lift struts (29-297573), two Bilstein front lift springs (E4-FD1-Y584B00), two Bilstein B6 rear dampers (24-195706) and two front driveshaft/CV bolt kits (OCT3318) for both sides as they MUST be replaced.

Bilstein’s B6 range is the ideal high quality OE replacement, designed to deliver both performance and comfort no matter the demand. This range provides higher power reserves and a longer service life even when pulling transporters and trailers or during frequent journeys with loads. They also create higher traction and more precise handling thanks to Bilstein’s gas-pressure technology.

This kit utilises Bilstein’s Amarok front lift struts and springs, which provides a better ride with added performance. These struts and springs are adjustable from +20mm to +50mm, allowing you to customise your ride height and comfort.

Product benefits:

Higher power reserves and longer service life even when pulling transporters and trailers or during frequent journeys with loads
Optimum grip and enhanced lane stability in day-to-day and extreme situations
Perceivably enhanced safety and performance without additional spring exchange (use of series spring possible)
High traction and more precise handling thanks to BILSTEIN gas-pressure technology
BILSTEIN mono-tube Upside-Down technology possible
Individually fine-tuned in the BILSTEIN road test
No parts certification required

You may also be interested in:

Febi Bilstein Rear Wheel Bearing Replacement Kit - 185950

This is to repair a worn or broken rear wheel bearing on the 2010-2022 Volkswagen Amarok vehicles and comes with the ABS sensor ring.

Currently, VAG doesn't supply a bearing separately for the Amarok; they require you to replace the whole rear axle shaft assemblies, which are sided and cost over £1500 per side!

Fits left and right rear hubs (normal and reverse thread rings supplied with each kit). Fits all MK1 Amarok models. You will need 2 kits to do both sides of your Amarok. Comes supplied with a 3-year warranty